When using rough terrain scissor lifts, it is really vital to utilize extra caution and be completely aware of your environment in order to maintain safety. The extended booms on the machine act as levers from the drive unit's center. For example, a 6 inch bump can result in a 3 foot bounce when the operator is at the driver controls. Take into consideration all other traffic nearby, as they might not be aware that you are moving. Plan your assent carefully. Park the boom lift on a flat surface that has no water or mud. These areas conceal deep potholes that could be possibly cause the occupants to fall if the tires fell into the holes. If provided, utilize all of the outriggers, extended to their full extension position. Be sure to just use wooden chalk blocks which are approved.
A lot of lifts operate from a metal platform on the end of the boom. The extended booms act as levers from the drive unit's center. A 6-inch bump can cause a 3-foot bounce while you are at the driver controls. Be aware of all other traffic. They might not be aware that you are moving. Plan your assent. Park the boom lift on a flat surface free of any water or mud. These areas could cover deep potholes in which the lift tires can fall, tipping the occupants. Extend all outriggers, if provided, fully. Place only approved wooden chalk blocks beneath the outrigger pads to prevent the unit from moving.
A serious hazard for lift drivers is overhead power lines. This is due regardless of what type of lift is utilized. For example, if the platform driver is not being aware, or if the platform is being controlled by ground personnel which could not accurately access nearness to wiring and therefore, either the platform itself or the worker can be easily brought into contact with electrical wires. The worker could be electrocuted unfortunately unless correctly insulated.